Passenger Elevator
Quiet rides for apartments, offices, hotels and towers.
OKFIT 200 · OKFIT 300 · V100 · V200
- 450–2,500 kgCapacity
- 6–33Persons
- 0.5–2.5 m/sSpeed
Quiet, smooth rides for every building.
Four models cover every building, from apartments and clinics to hotels, malls and towers: OKFIT 200, OKFIT 300, V100 and V200. All run without a machine room, with automatic centre- or side-opening doors and up to 20 stops. Send us the shaft width and depth and the number of stops, and we choose the model and the largest standard car that fits.
Specifications
The final quotation confirms the equipment, warranty, service coverage, response arrangements and payment terms for your project.
- Models
- OKFIT 200 · OKFIT 300 · V100 · V200
- Capacity
- 450–2,500 kg
- Persons
- 6–33
- Speed
- 0.5–2.5 m/s
- Doors
- Automatic, centre or side opening
- Stops
- Up to 20
- Pit · headroom
- 1,200 · 3,600 mm minimum
- Machine room
- None
- Structure
- Your shaft, or a steel structure (shaft + 100 mm)
- Warranty
- As quoted
Before you enquire
Share what you know. You can leave unknown measurements blank; the final solution depends on a site assessment.
- The building location and whether it is new or existing.
- The intended use, required capacity and number of levels, where relevant.
- Available clear dimensions, photographs or drawings, if available.
- Access, power supply and the target project timing.
Understanding the specification
- Capacity
- The rated load shown for a model; the proposed load must suit the intended use.
- Clear dimensions
- The unobstructed space available, measured between finished surfaces.
- Pit and headroom
- For a shaft lift, the space below the lowest landing and above the highest landing. Confirm these against the selected model.
Resources
For initial planning only. This is not a fabrication drawing or an approved project specification. Confirm the selected model, dimensions and site requirements with BAYERN.
Print / Save as PDFEntrance layouts
Doors on one side, on two opposite sides, or on two sides at 90°. Opposite openings need a deeper shaft.
- A · Frontal: doors on one side.
- B · Opposite: front and rear.
- C · Lateral: two sides at 90°.
Four models
Each model is drawn to the same scale in the catalogue; the example shows a typical car and the shaft it needs. Sizes in mm, clear inside.
| Model | Best for | Capacity | Persons | Speed | Doors | Example car → shaft |
|---|---|---|---|---|---|---|
| OKFIT 200 | Apartments, offices, clinics | 450–1,000 kg | 6–13 | 1.0–1.75 m/s | Centre opening | 1,100 × 1,400 → 1,800 × 1,820 |
| OKFIT 300 | Stretchers, beds and goods: a deep car | 630–1,600 kg | 8–21 | 0.5–1.0 m/s | Side opening | 1,000 × 1,850 → 1,600 × 2,150 |
| V100 | Busy offices, hotels, malls | 450–1,600 kg | 6–21 | 1.0–2.0 m/s | Centre opening | 1,400 × 1,500 → 2,300 × 2,180 |
| V200 | Towers and heavy traffic | 750–2,500 kg | 10–33 | 1.75–2.5 m/s | Centre opening | 1,200 × 1,500 → 2,000 × 1,800 |
Swipe sideways to see the whole table.
A steel structure is available for every model.
Choose your size
Pick the load, read the shaft you need. Counterweight at the side; rear drop on request. With a steel structure, add 100 mm to the shaft. Sizes in mm, clear inside.
OKFIT 200 · centre-opening doors
| Load · persons | Car | Shaft | Door |
|---|---|---|---|
| 450 kg · 6 | 1,000 × 1,250 | 1,700 × 1,670 | 800 |
| 630 kg · 8 | 1,100 × 1,400 | 1,800 × 1,820 | 850 |
| 800 kg · 10 | 1,350 × 1,400 | 2,050 × 1,820 | 1,000 |
| 1,000 kg · 13 | 1,600 × 1,400 | 2,300 × 1,820 | 1,100 |
OKFIT 300 · side-opening doors, deep car
| Load · persons | Car | Shaft | Door |
|---|---|---|---|
| 630 kg · 8 | 1,000 × 1,600 | 1,600 × 1,900 | 800 |
| 1,000 kg · 13 | 1,100 × 2,100 | 1,700 × 2,400 | 900 |
| 1,275 kg · 17 | 1,200 × 2,300 | 1,800 × 2,600 | 1,000 |
| 1,600 kg · 21 | 1,400 × 2,400 | 2,000 × 2,700 | 1,200 |
V100 · centre-opening doors
| Load · persons | Car | Shaft | Door |
|---|---|---|---|
| 630 kg · 8 | 1,100 × 1,400 | 2,000 × 2,080 | 900 |
| 800 kg · 10 | 1,350 × 1,400 | 2,250 × 2,080 | 1,100 |
| 1,000 kg · 13 | 1,600 × 1,400 | 2,500 × 2,080 | 1,200 |
| 1,275 kg · 17 | 2,000 × 1,400 | 2,900 × 2,080 | 1,300 |
| 1,600 kg · 21 | 2,100 × 1,600 | 3,000 × 2,280 | 1,300 |
V200 · centre-opening doors
| Load · persons | Car | Shaft | Door |
|---|---|---|---|
| 1,000 kg · 13 | 1,600 × 1,400 | 2,400 × 1,700 | 1,150 |
| 1,275 kg · 17 | 2,000 × 1,400 | 2,800 × 1,700 | 1,300 |
| 1,600 kg · 21 | 2,100 × 1,600 | 2,900 × 1,900 | 1,300 |
| 2,000 kg · 26 | 2,400 × 1,700 | 3,200 × 2,000 | 1,300 |
| 2,500 kg · 33 | 2,400 × 2,000 | 3,200 × 2,300 | 1,300 |
Rated load follows the car floor area. Opposite openings need a deeper shaft.
Bayern Elevator Cloud
Monitoring and support options depend on equipment compatibility and your service agreement.
Your next steps
A clear scope, coordinated installation and an agreed service plan.
Questions
Can you fit a lift in an existing building?
Yes. We work on finished buildings and on those still being built. A survey shows what your building needs.
What warranty do I get?
5 years on all BAYERN equipment.
Who looks after it?
Our own team, on a monthly or yearly service plan, with an emergency line day and night and a 37-minute average response.
Do you service lifts you did not install?
Yes. Maintenance, audits and repairs can be booked on their own, for any make, anywhere in Qatar.
Why install a lift at home?
Discuss access between floors, the needs of the people using the building and the available installation space.
More vertical transportation
Final specifications, price, programme, warranty and maintenance scope are confirmed in your written quotation and contract. Help & FAQs
Let’s talk
Tell us what you need. We will review the information and agree the next step with you.
- Phone
- 4415 4641
- Mobile / WhatsApp
- 6644 0248
- info@bayern.qa
